Tools You Actually Need
- TPMS activation/scan tool that supports Roewe and 433MHz sensors
- OBD2 interface if you are doing an OBD relearn
- Accurate tire pressure gauge and air compressor
- Owner’s manual or service data for trigger order and reset speed
- New clamp-in service kit if the original valve stem, nut, or seal is worn
- Torque wrench set to the manufacturer’s clamp-in nut specification
Three Relearn Methods
Auto Relearn
Install the sensors, inflate tires to the door placard pressure, then start the vehicle. Some Roewe models learn new sensor IDs automatically after driving; others need the TPMS tool to wake each sensor first. If the light does not clear after the specified drive cycle, move to stationary or OBD relearn.
OBD Relearn
Connect an OBD2 tool that supports TPMS relearn. Select Roewe, then TPMS, then Relearn or ID Write. Follow the tool prompts. It may ask you to trigger each sensor in order. OBD relearn is the most reliable method when installing new sensors or when the auto relearn fails.
Stationary Relearn
Park the vehicle, turn ignition on, and enter relearn mode through the scan tool or dash procedure. Trigger the sensors in the order shown on the tool—usually left front, right front, right rear, left rear—and listen for the horn or chime after each one. Turn ignition off, restart, and verify the TPMS light is out. Some Roewe models still require an OBD tool to enter this mode.
Sensor Fitment Notes
| Item | Detail |
|---|---|
| Sensor | BH-Sens BL-ST-021 |
| Frequency | 433 MHz |
| Type | Clamp-in, pre-programmed |
| OE cross-reference | 10290600, 10625492, 10718213, 11205327 |
| Compatible brands | Im, MG, Rising, Roewe |
| Fitment check | Verify by VIN or original sensor number |
For a direct replacement, the BH-Sens BL-ST-021 BL-ST-021 | BH-Sens 433MHz TPMS Tire Pressure Sensor | Fits Im, MG, Rising, Roewe | OE# 10290600, 10625492, 10718213 is a 433MHz clamp-in sensor that comes pre-programmed and is listed for Im, MG, Rising,